Hardware options installation 36
15.
Connect the front panel LED board cable.
16. Install the BBWC holder and optional battery with attached cable, if applicable.
17. Install the fan assembly (on page 20).
18. Install the access panel.
19. Install the server into the rack.
Diskette drive option
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1. Power down the server (on page 16).
2. Remove the server from the rack (on page 17).
3. Remove the access panel (on page 17).
4. Remove the fan assembly (on page 19).
5. Remove the BBWC holder ("Remove the BBWC battery holder" on page 21) and optional battery
with cable, if installed.
To Next Page
Loading...
