HP ProLiant DL320 Generation 5 - PCI Riser Board Option

Hardware options installation 45
5.
Remove the PCI riser board assembly (on page 18).
6. Remove the expansion slot cover.
7. Install the expansion board.
8. Install the PCI riser board assembly (on page 18).
9. Install the access panel.
10. Install the server into the rack.
PCI riser board option
1. Power down the server (on page 16).
2. Extend the server from the rack, if applicable ("Extend the server from the rack" on page 17).
3. Remove the access panel (on page 17).
4. Disconnect any internal or external cables connected to any existing expansion boards.
5. Remove the PCI riser board assembly (on page 18).