Hardware options installation 40
13.
Connect the diskette drive cable to the diskette drive.
14. Connect all cables to other devices installed in the media cage, if necessary.
15. Connect the front panel LED board cable.
16. Install the BBWC holder and optional battery with attached cable, if applicable.
17. Install the fan assembly (on page 20).
18. Install the access panel.
19. Install the server into the rack.
Video connector option
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
1. Power down the server (on page 16).
2. Remove the server from the rack (on page 17).
3. Remove the access panel (on page 17).
To Next Page
Loading...
