Removal and replacement procedures 35
4.
Remove the drive carrier.
To replace the component, slide the component into the bay until it clicks.
Non-hot-plug drive
CAUTION: To prevent improper cooling and thermal damage, do not operate the server
unless all bays are populated with either a component or a blank.
To remove the component:
1. Back up all server data on the drive.
2. Power down the server (on page 27).
3. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
4. If installed, remove the security bezel ("Remove the security bezel (optional)" on page 26).
5. Remove the non-hot-plug drive.
To Next Page
Loading...
