1. In the iLO Configuration Utility window, click Access Settings.
The Access Options tab data appears:
2. Edit the option(s) as necessary. Click Apply.
Access Settings–Access Options
• Idle Connection Timeout (minutes)—Specifies how long a user can be inactive before the iLO
web interface or Remote Console session ends automatically. The iLO web interface and the
Remote Console track idle time separately because each connection is a separate session.
Remote Console sessions are not affected by this value if a virtual media device is connected.
The following settings are valid:
◦ 15, 30, 60, or 120 minutes—The default value is 30 minutes.
◦ Infinite—Inactive users are not logged out.
Failure to log out of iLO by either browsing to a different site or closing the browser also results
in an idle connection. The iLO firmware supports a finite number of iLO connections. Misuse
of the Infinite timeout option might make iLO inaccessible to other users. Idle connections are
recycled after they time out.
This setting applies to local and directory users. Directory server timeouts might preempt the
iLO setting.
Changes to the setting might not take effect immediately in current user sessions, but will be
enforced immediately in all new sessions.
• iLO Functionality—Specifies whether iLO functionality is available. The following settings are
valid:
◦ Enabled (default)—The iLO network is available and communications with operating
system drivers are active.
◦ Disabled—The iLO network and communications with operating system drivers are
terminated when iLO Functionality is disabled.
To re-enable iLO functionality, use the iLO 4 Configuration Utility (in the UEFI System Utilities)
to set iLO Functionality to Enabled. For more information see the HP UEFI System Utilities User
Guide.
Using iLO Configuration Utility 51
To Next Page
Loading...
