◦ Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCPv4
server-supplied time.
◦ Use DHCPv4 Supplied WNS Servers—Specifies whether iLO uses the DHCP server-supplied
WINS server list. If not, enter the WINS server addresses in the Primary WINS Server
and Secondary WINS Server boxes.
• IPv4 Address—The iLO IP address. If DHCP is used, the iLO IP address is supplied automatically.
If DHCP is not used, enter a static IP address.
• Subnet Mask—The subnet mask of the iLO IP network. If DHCP is used, the subnet mask is
supplied automatically. If DHCP is not used, enter a subnet mask for the network.
• Gateway IPv4 Address—The iLO gateway IP address. If DHCP is used, the iLO gateway IP
address is supplied automatically. If DHCP is not used, enter the iLO gateway IP address.
• Static Route #1, Static Route #2, and Static Route #3—The iLO static route destination, mask,
and gateway addresses. If Use DHCPv4 Supplied Static Routes is used, these values are supplied
automatically. If not, enter the static route values.
• Primary DNS Server—Enter the IPv4 address for the primary DNS service.
• Secondary DNS Server—Enter the IPv4 address for the secondary DNS service.
• Tertiary DNS Server—Enter the IPv4 address for the tertiary DNS service.
NOTE: When DNS server locations are configured in both IPv4 and IPv6, both sources are used,
with preference given according to the iLO Client Applications use IPv6 first configuration option,
primary sources, then secondary, and then tertiary.
• Enable DNS Server Registration—Select this option to enable iLO to register its IPv4 address
and name with a DNS server.
• Primary WINS Server—Enter the IPv4 address for the primary WINS server.
• Secondary WINS Server—Enter the IPv4 address for the secondary WINS server.
• Enable WINS Server Registration—Select this check box to enable iLO to register the IPv4
address for the WINS server(s).
• Ping Gateway on Startup—Select this check box to have iLO send request packets to the
gateway when iLO initializes.
To edit the settings on the IPv4 tab:
1. In the iLO Configuration Utility window, click Network Settings. The General tab data appears.
2. Click the IPv4 tab. The IPv4 tab data appears.
Using iLO Configuration Utility 61
To Next Page
Loading...
