• Static Default Gateway—Enter a default IPv6 gateway address for cases in which no router
advertisement messages are present in the network.
• Static Route #1 (Destination/Gateway), Static Route #2 (Destination), Static Route #3—Enter
static IPv6 route destination prefix and gateway address pairs. You must specify the prefix
length for the destination. Link-local addresses are not allowed for the destination, but are
allowed for the gateway.
To edit the settings on the IPv6 tab:
1. In the iLO Configuration Utility window, click Network Settings. The General tab data appears.
2. Click the IPv6 tab. The IPv6 tab data appears.
3. Edit the setting(s) as necessary. Click Apply.
Network Settings–SNTP
• Use DHCPv4 Supplied Time Settings—Specifies whether iLO uses the DHCP server-supplied
time.
• Use DHCPv6 Supplied Time Settings—Specifies whether iLO uses version 6 of the DHCP
server-supplied time.
• Propagate NTP Time to Host—Specifies whether ILO uses NTP time instead of the DHCP
server-supplied time.
• Primary Time Server—If DHCPv4 or DHCPv6 SNTP is not used, enter a time server address
in the Primary Time Server box.
• Secondary Time Server—If DHCPv4 or DHCPv6 SNTP is not used, enter a secondary time
server address in the Secondary Time Server box.
• Time Zone—A drop-down list of worldwide time zones.
To edit the settings on the SNTP tab:
1. In the iLO Configuration Utility window, click Network Settings. The General tab data appears.
2. Click the SNTP tab. The SNTP tab data appears.
Using iLO Configuration Utility 63
To Next Page
Loading...
