HP ProLiant MicroServer User Manual

Hardware options installation 29
5.
Install the TPM board. Press down on the connector to seat the board.
6. Install the TPM security rivet by pressing the rivet firmly into the system board.
7. Close the panel door.
8. Power up the server (on page 6).
Retaining the recovery key/password
The recovery key/password is generated during BitLocker™ setup, and can be saved and printed after
BitLocker™ is enabled. When using BitLocker™, always retain the recovery key/password. The recovery
key/password is required to enter Recovery Mode after BitLocker™ detects a possible compromise of system
integrity.
To help ensure maximum security, observe the following guidelines when retaining the recovery
key/password:
• Always store the recovery key/password in multiple locations.
• Always store copies of the recovery key/password away from the server.

HP ProLiant MicroServer Specifications

General

Maximum Memory	16GB
RAID Support	RAID 0, 1, 10
Network	1 x Gigabit Ethernet port
Expansion Slots	1 x PCIe 2.0 x1
Power Supply	150W
Form Factor	Micro Tower
Drive Bays	4 x 3.5" internal drive bays
Dimensions	9.65 x 9.65 inches (245 x 245 mm)
Storage	Up to 4 x 3.5" SATA