HP ProLiant ML350 Gen9 - Page 63

Removal and replacement procedures 63
o
If two SAS Expander cards are installed, connect the 1000 mm Smart Array to Expander
Mini-SAS Y cable (778559-001) from the Smart Array controller (port 1I) to the second SAS
Expander card ports 1 and 2.
12. Connect the three Expander to backplane Mini-SAS X cables from the SAS Expander cards to each
backplane according to the table below. For more information, see "Device numbering (on page
90)".
o One SAS Expander
Expander
connectors
LFF configuration SFF configuration
Port 3
Port 4
Box 1
Box 4
Port 5
Port 6
Box 2
Box 5
Port 7
Port 8
Box 3
Box 6
o Two SAS Expanders
SAS Expander
connector
First SAS
Expander
Second SAS
Expander
Port 3
Port 4
Box 4
Box 1
Port 5
Port 6
Box 5
Box 2
Port 7
Port 8
Box 6
Box 3
13. Install the expander card.
14. Route the cables and secure them under the cable clips.
o One SAS Expander