HP ProLiant ML350p Gen8 Maintenance And Service Guide

Removal and replacement procedures 36
ii.
Disconnect each power cord from the server
d. Remove the access panel ("Access panel" on page 29).
e. Remove the rack bezel.
3. Remove the component box blank.
To replace the component, reverse the removal procedure.
Drive blank
To remove the component:
1. Do one of the following:
o For tower models, open and remove the bezel ("Remove the tower bezel" on page 27).
o For rack models, if install, remove the security bezel (on page 27).
2. Remove the drive blank.
To replace the component, reverse the removal procedure.
Drive

HP ProLiant ML350p Gen8 Specifications

General

Processor	Intel Xeon E5-2600 series
Maximum Processors	2
Chipset	Intel C600 Series
Memory Type	DDR3 RDIMM or UDIMM
Maximum Memory	768 GB
Memory Slots	24 DIMM slots
RAID Support	HP Smart Array P420i/1GB FBWC
Storage Controller	HP Smart Array P420i/1GB FBWC
Network Controller	HP Ethernet 1Gb 4-port 331FLR Adapter
Form Factor	Tower
Storage	SAS, SATA, SSD
Network	Gigabit Ethernet
Power Supply	460W, 750W, 1200W
Power Supply Options	Redundant Power Supplies
Operating System Support	Microsoft Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware