HP ProLiant ML350p Gen8 - Power Supply Blank

Removal and replacement procedures 40
b.
Remove the access panel ("Access panel" on page 29).
5. For rack models, do the following:
a. Extend the server from the rack (on page 28).
b. Remove the access panel ("Access panel" on page 29).
c. Release thumbscrews and remove the rack bezel.
6. Remove the air baffle ("Air baffle" on page 30).
7. Remove the fan cage.
8. Remove the front I/O module assembly.
To replace the component, reverse the removal procedure.
Power supply blank
Remove the blank.
To replace the component, reverse the removal procedure.