Removal and replacement procedures 56
2.
Remove the heatsink protective cover.
3. Install the heatsink, and then close the heatsink retaining levers.
4. Install the air baffle.
5. Install the access panel.
6. Do one of the following:
o For tower models, return the server to an upright position, and then install the bezel.
o For rack models, slide the server back into the rack.
7. Connect each power cord to the server.
8. Connect each power cord to the power source.
9. Press the Power On/Standby button.
The server exits standby mode and applies full power to the system. The system power LED changes
from amber to green.
To Next Page
Loading...
