HP R/T3000 G2 User Manual

80 pages

To Next Page

To Previous Page

Component identification 12

IMPORTANT: Pressing and holding the On button without utility present normally initiates a

battery start and the UPS assumes the load. However, if the On button is pressed and a REPO is

detected, battery start is inhibited and the UPS is not able to assume the load. The electronics

module fan spins, and the Self Test, Battery Fault, Site Wiring Fault, and Overtemperature LEDs

and an audible alarm are active as long as the On button is held.

To power down the entire network in the event of an emergency, the REPO ports of multiple UPS units can be

connected to a single switch.

ERM rear panel

Item Description

Circuit breaker

ERM output connector cable (to the UPS)

ERM input connector (from another ERM)

Other manuals for HP R/T3000 G2

Need help?

Do you have a question about the HP R/T3000 G2 and is the answer not in the manual?

General