Chapter 2: Install the server components 10
Chapter 2: Install the server components
This section contains the following topics:
• Electrostatic discharge
• Shipping carton contents
• Components not supplied in the shipping carton
• Rack requirements
• Rack installation guidelines
• Install the server in a rack
• Connect the power cables
• Connect the network cables
• Organize the cables
• Power up the server
To install the server components, you must unpack all components, install the server in a rack, connect the power
and network cables, and power on the system.
Electrostatic discharge
You must protect sensitive components from electrostatic discharge (ESD).
To protect components from ESD:
• Ensure the component is fully grounded at all times to prevent damage from electrostatic discharge.
• When not installed in a rack, store server components in the original packaging or place on a sturdy surface
that is protected from electrostatic discharge.
• When handling server components, always use the electrostatic wrist strap provided or a similar form of ESD
protection.
Shipping carton contents
The shipping carton contains standard items and other items based on your configuration.
Part Description
Server Provides processing power and storage capacity.
Power cords • Two standard power cords.
• Two IEC C13/C14 (PDU) cords.
Rack-mounting hardware (optional) Contains the left and the right rails and detailed installation
documentation.
Cable Management Arm (CMA) kit (optional) Contains the CMA assembly and installation documentation.
To Next Page
Loading...
Need help?
General