To Next Page

To Previous Page

Device Type...................................... DISK

Disk Capacity.................................... 73.4 GB

Device Status.................................... OK

Device Vendor ID................................. HP

Device Product ID................................ DH072ABAA6

Device Serial Number............................. 3PD0J4A000009748XQZG

Device Firmware Version.......................... HPD2

Reserved Area (cfg/status info).................. 33554.4 KB (33.6 MB)

Block Size (bytes/sector)........................ 512 bytes

M&P Data Stamped?................................ yes

Last Failure Reason.............................. INIT RESET RECOVERY ABORTED

Physical Disk Flags:

Disk present and operational................... yes

Non-disk device detected....................... no

S.M.A.R.T. supported........................... yes

S.M.A.R.T. errors (in factory M&P data)........ no

S.M.A.R.T. enabled............................. yes

S.M.A.R.T. errors (in powerup M&P data)........ no

Attached to external connector................. yes

Configured in a logical drive.................. yes

Configured as a spare disk..................... no

Disk write cache enabled at spin up............ no

Supports redundant controller operation........ no

Disk write cache enabled in current page....... no

Disk write cache disabled in default page...... yes

---- SAS/SATA DEVICE 1E:1:4:0x5000c500052d5175 [DISK] ------------------------

Connector Location............................... external

Connector........................................ 1E

Enclosure........................................ 1

Bay.............................................. 4

WWID............................................. 0x5000c500052d5175