To Next Page

To Previous Page

Connector Location............................... external

Connector........................................ 1E

Enclosure........................................ 1

Bay.............................................. 0

WWID............................................. 0x50001c1071540025

Device Type...................................... SES

Disk Capacity.................................... 0.0 GB

Device Status.................................... FAILED

Device Vendor ID................................. HP

Device Product ID................................ MSA70

Device Serial Number............................. SGA728007J

Device Firmware Version.......................... 1.42

Reserved Area (cfg/status info).................. 0.0 KB (0.0 MB)

Block Size (bytes/sector)........................ 0 bytes

M&P Data Stamped?................................ yes

Last Failure Reason.............................. NON DISK DEVICE

Physical Disk Flags:

Disk present and operational................... no

Non-disk device detected....................... yes

S.M.A.R.T. supported........................... no

S.M.A.R.T. errors (in factory M&P data)........ no

S.M.A.R.T. enabled............................. no

S.M.A.R.T. errors (in powerup M&P data)........ no

Attached to external connector................. yes

Configured in a logical drive.................. no

Configured as a spare disk..................... no

Disk write cache enabled at spin up............ no

Supports redundant controller operation........ no

Disk write cache enabled in current page....... no

Disk write cache disabled in default page...... no

---- SAS/SATA DEVICE 2E:1:0:0x5001438000328825 [SES] -------------------------