6. Rebooting the system is complete when you receive the “Initializing node#”, then “Initializing for
node# completed.” messages for all nodes in the systems notifications.
Rebooting the System
To reboot the system from VLS CLI:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. Open a secure shell session and log in as the administrator. See
“Opening a Secure Shell Session” on page 108.
3. Initiate a reboot of the VLS by entering:
restartSystem
To reboot the system from Command View VLS:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. Open a Command View VLS session and log in as the administrator. See
“Opening a Command View VLS Session from a Web Browser” on page 105.
3. Under the System tab, select Chassis in the navigation tree.
4. Under Maintenance Tasks, select System Maintenance.
5. Select Restart All Nodes from the task bar.
Restart Head Wizard displays.
6. Select Yes to reboot all nodes.
CAUTION:
Rebooting the VLS device places the VLS cartridges back into the same library slots and tape drives
they were in at the time of reboot. To move the cartridges from tape drives back into the appropriate
slots, use Force Unload from the task bar visible when you select the tape drive from the navigation
tree.
Powering Off the System
WARNING!
To reduce the risk of personal injury, electric shock, or damage to the equipment, remove
the power cord to remove power from the node before removing the access panel. The front panel
Power On/Standby button does not completely shut off system power. Portions of the power supply
and some internal circuitry remain active until AC power is removed.
To power off the system from the VLS CLI:
1. Verify that any backup or restore operation has completed and that the VLS is idle.
2. Open a serial session and log in as the administrator. See
“Opening a Serial Session” on page 109.
Operation100
To Next Page
Loading...
