2. Slide the drive into the bay until it clicks.
Figure 60 Installing the DVD-CD drive
.
Power Supply
CAUTION:
To prevent improper cooling and thermal damage, do not operate the node unless all bays are
populated with either a component or a blank.
1. Disconnect the power cord from the power supply.
2. Press the power supply release lever (1), and then pull the power supply from the node.
Figure 61 Removing a node power supply
.
To replace the component:
WARNING!
To reduce the risk of electric shock or damage to the equipment, do not connect the power cord to
the power supply until the power supply is installed.
1. Remove the protective cover from the connector pins on the power supply.
HP StorageWorks 205
To Next Page
Loading...
