Ethernet Switch 2810–24G Components, LEDs, and Buttons
Front Panel Components
DescriptionItem
Console port1
10/100/1000Base-T RJ-45 ports 1 through 20
(numbered from top to bottom, left to right)
2
10/100/1000–T dual-personality ports 21 through 243
10/100/1000 mini-GBIC dual-personality ports 21 through 244
Front Panel LEDs and Buttons
StatusDescriptionItem
When pressed with the Reset button in a specific pattern, any configuration
changes you may have made through the switch console, the Web browser
interface, and SNMP management are removed, and the factory default
configuration is restored to the switch.
Clear button1
Used to reset the switch while it is turned on. This action clears any temporary
error conditions that may have occurred and executes the switch self-test.
Reset button2
Blinking blue = Locate function is active. Firmware controlled, can be set to
on or blinking.
Off = Locate function is disabled.
Locator LED3
HP StorageWorks 195
To Next Page
Loading...
