58 HP StorageWorks XP10000 Disk Array Site Preparation Guide
Removing packaging materials
The primary rack is labeled DKC AE102A. If you ordered a two-rack
system, unpack the primary rack first because it contains the wooden ramp
you will use to unload both equipment racks.
1. If shipped in a wooden crate:
a. Using an 11mm (7/16") ratchet or wrench, remove the six lag screws
at the base of the crate.
b. Using the claw end of a claw hammer, remove the crate clamps.
Warning
Crate clamps are under tension. Wear safety glasses and hold onto the
clamp with your free hand during removal.
c. Remove the crate panels.
To Next Page
Loading...
