56 HP StorageWorks XP10000 Disk Array Site Preparation Guide
• Scissors or box knife to cut polyester banding
• Safety glasses
• Short stepladder (helpful, but not required)
Unpacking process
If you need to unpack the equipment without HP supervision, follow the
instructions in this section.
1. Following the steps “Removing packaging materials” (page 58), unpack
the equipment cartons outside of the computer room to avoid debris and
possible contamination of the computer room environment.
2. For software CDs, cables, and other installation hardware, leave the
sealed cartons or packages intact. HP representatives will unpack them
when they install and configure the disk array.
3. As you unpack the cartons, match the delivered items to the packing list
(invoice) for each carton. Contact your HP SR immediately if any items
are missing or are not the ones you ordered.
4. Move all equipment to the computer room before the installation date.
Safety precautions
Caution Be very careful when handling the equipment. Do not drop the equipment
from a height of more than 0.5 cm (0.2 in). Floor unevenness must be less
than 1 cm (0.4 in).
Warning
The equipment frames are very heavy. To avoid injury, use appropriate
lifting tools and have three people unpack and move the equipment.
To Next Page
Loading...
