Table 40 Warning event codes (continued)
Details and SolutionDescriptionEvent code
Invalid upgrade cartridge. Drive has rejected the
cartridge as invalid.
65
• Retry the operation.
• If problems persist, exchange the data
cartridge.
The diagnostic test needs to write data but the
tape being used for the test is write protected.
Diagnostic tape write protect.66
Ensure that the device has a tape that is not write
protected for use during the diagnostic test.
The drive tried to read or write data from a tape
from an incompatible LTO generation. For
Incompatible medium67
compatibility information see “Backward read
compatibility” (page 45).
Check the SCSI cable connection and verify that
the maximum cable length is not exceeded. Verify
that the SCSI bus is properly terminated.
SCSI message error70
SCSI parity error71
SCSI invalid message72
The application software made an illegal request.SCSI: overlapped command attempt73
SCSI: echo buffer overwritten74
Update the library to the most current firmware
version.
Download prevented — barcode reader
hardware requires newer code revision.
75
This can happen if a cartridge is moved without
the library completing a full inventory. Rescan the
tapes from the RMI or OCP.
Destination element unexpectedly full.76
Update the library to the most current firmware
version.
Download prevented because of an incompatible
library controller.
77
Update thelibrary to the most current firmware
version.
Download prevented because of incompatible
robot firmware.
78
The library will only accept signed firmware
images. Download a signed firmware image.
Invalid firmware version. Only signed firmware
images are allowed.
7B
Recovered error move operation. No action
required. Occasional retries are normal operation.
Movement retry. Robotics movement did not
succeed but was successful on a retry.
80
• Check the tape drive fan on the library back
panel to see whether the fan is operational
and not obstructed.
NOTE: The sub-error code indicates the
affected tape drive. For example, 00 is drive 1
and 01 is drive 2.
NOTE: Fan only operates when cooling is
required.
Drive sled fan alert. Fan motion has stopped.81
Clean the indicated tape drive using a valid
cleaning tape.
Clean request from the tape drive82
NOTE: The sub-error code indicates the
affected tape drive. For example, 00 is drive 1
and 01 is drive 2.
Evaluate media status using L&TT.Media attention83
Evaluate drive status using L&TT.Tape drive tape alert; tape drive reported a
warning or critical tape alert.
84
178 Troubleshooting
To Next Page
Loading...
