HP StoreEver MSL4048

Table 51 Default settings (continued)
Stored in Saved Config
fileReset by Set DefaultsDefault settingParameter
YesYesDrive 1 or the lowest numbered existing
drive
Master drive
YesYesDrive powered onAll drives powered onDrive power
YesDisabledAuto clean
Slots
YesMaximum possibleActive slots
YesYes0Reserved slots
YesYesMailslot disabledMailslot
configuration
YesYesEnabledAdministrator
password required
for mailslot
removal
Barcode reader settings
YesYes8Barcode reader
label length
YesYesLeftBarcode reader
alignment
YesYesDisabledIgnore barcode
Media ID
Error and event settings
YesYesContinuous trace and all levels and
filters active (for Hewlett Packard
Enterprise Service use only)
Event log levels
and filter
YesOnError recovery
YesYes, but configurations
retained
DisabledE-mail notification
YesNoUnsetAdministrator
password
Yes, including DHCP,
DNS, IPv4 and IPv6
addresses
No. The network is always
enabled and the network
addresses are retained.
Network settings
YesYesDisabledHTTPS
YesYes, but saved address do
not change
Disabled, but saved addresses do not
change
SNMP
YesYesEnabledRestricted
network access
Miscellaneous settings
YesYesAutomaticLibrary mode
NoBlank or existingDate and time
YesTBDDefault factory settingDisplay contrast
setting (MSL4048,
208 Specifications