Table 51 Default settings (continued)
Stored in Saved Config
fileReset by Set DefaultsDefault settingParameter
MSL8048, and
MSL8096 only)
YesYesDisabled (no logical libraries)Logical library
configuration
YesNot applicableDisabledEncryption and
security settings
YesNoNoneLicense Keys
IMPORTANT: When the defaults are restored, the library will rediscover and renumber the
tape drives from the bottom of the library up. If a tape drive was added between two other tape
drives since the last time the drives were discovered, that tape drive and the ones above it will
be renumbered. You might need to update the configuration of the backup application when tape
drives are renumbered.
Default and restore defaults settings 209
To Next Page
Loading...
