Figure 17: Power button on disk enclosure
Powering off the disk enclosure
There are no StoreOnce CLI commands to power off the disk enclosure. Use the Power On/Off button (1)
on the rear of the disk enclosure to power off the unit.
Figure 18: Power button on disk enclosure
After replacing a component
Use the StoreOnce GUI or StoreOnce CLI to check that the firmware on the new component is correct.
See Upgrading BIOS or hardware firmware components on page 16.
NOTE: The system reboots after a firmware upgrade, but for some components a cold reboot is required
to complete the process. A message is displayed after the reboot if a cold reboot is also required. Power
down the system, wait the time recommended in the message and then power on again using the Power
On button.
Powering off the disk enclosure 47
To Next Page
Loading...
