HP t610 Series Hardware Reference Guide

WARNING! You must remove the left side panel to access the system board. Before removing the
side access panel, ensure that the thin client is turned off and the power cord is disconnected from the
electrical outlet.
CAUTION: Static electricity can damage the electronic components of the computer or optional
cards. Before beginning these procedures, ensure that you are discharged of static electricity by briefly
touching a grounded metal object. When handling a memory module, be careful not to touch any of
the contacts. Doing so may damage the module.
To install the flash memory module:
1. If an internal hard drive is installed, remove it. See
Removing an internal hard drive on page 21
for instructions.
2. Locate the correct flash memory module socket on the system board.
a. The PATA socket (1) is populated by default.
b. The SATA socket (2) can be populated with an optional SATA flash memory module.
Figure 2-12 Identifying the Flash Memory Module sockets
Installing thin client options
19

HP t610 Series Specifications

General

Power Supply	65W external power adapter
Processor	AMD G-T56N APU with Radeon HD 6320 Graphics (1.65 GHz, 1 MB L2 cache)
Graphics	AMD Radeon HD 6320 Graphics
Memory	4 GB DDR3 SDRAM
Storage	500 GB HDD
Networking	Gigabit Ethernet
USB Ports	6 x USB 2.0 (2 front, 4 rear)
Operating System	HP ThinPro, Windows Embedded Standard 7
Chipset	AMD A55E
Ports	1 serial, 1 parallel