EasyManuals Logo

HP TouchSmart 9300 Elite User Manual

HP TouchSmart 9300 Elite
165 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #146 background imageLoading...
Page #146 background image
Diagnostics passes, but the computer does not communicate with the network.
Cause Solution
Network drivers are not loaded, or driver parameters do not
match current configuration.
Make sure the network drivers are loaded and that the driver
parameters match the configuration of the network controller.
Make sure the correct network client and protocol is installed.
The network controller is not configured for this computer. Select the Network icon in the Control Panel and configure
the network controller.
Network controller stopped working when an expansion board was added to the computer.
Cause Solution
Network controller interrupt is shared with an expansion
board.
Under the Computer Setup Advanced menu, change the
resource settings for the board.
The network controller requires drivers. Verify that the drivers were not accidentally deleted when the
drivers for a new expansion board were installed.
The expansion board installed is a network card (NIC) and
conflicts with the embedded NIC.
Under the Computer Setup Advanced menu, change the
resource settings for the board.
Network controller stops working without apparent cause.
Cause Solution
The files containing the network drivers are corrupted. Reinstall the network drivers, using the Recovery Disc Set
created from the hard drive's Recovery Partition.
The cable is not securely connected. Ensure that the cable is securely attached to the network
connector and that the other end of the cable is securely
attached to the correct device.
The network controller is defective. Contact an authorized service provider.
New network card will not boot.
Cause Solution
New network card may be defective or may not meet
industry-standard specifications.
Install a working, industry-standard NIC, or change the boot
sequence to boot from another source.
Cannot connect to network server when attempting Remote System Installation.
Cause Solution
The network controller is not configured properly. Verify Network Connectivity, that a DHCP Server is present,
and that the Remote System Installation Server contains the
NIC drivers for your NIC.
138 Appendix B Troubleshooting Without Diagnostics

Table of Contents

Other manuals for HP TouchSmart 9300 Elite

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP TouchSmart 9300 Elite and is the answer not in the manual?

HP TouchSmart 9300 Elite Specifications

General IconGeneral
RAMUp to 16 GB DDR3 SDRAM
Operating SystemWindows 7 Professional
TouchscreenYes
ProcessorIntel Core i5 or i7
Display23-inch diagonal widescreen LCD with LED backlight
StorageUp to 1 TB Hard Disk Drive or Solid State Drive
GraphicsIntel HD Graphics
Optical DriveDVD+/-RW SuperMulti DL
ChipsetIntel Q67 Express
AudioIntegrated high-definition audio
WebcamIntegrated 2 MP webcam
PortsUSB 2.0, RJ-45, audio in/out
NetworkingGigabit Ethernet, Wi-Fi

Related product manuals