Rear logo cover
The rear logo cover is secured with four screws.
To remove the rear logo cover:
1. Prepare the computer for disassembly (see
Preparing to disassemble the computer on page 33).
2. Remove the left and right rear panels (see
Rear panels on page 46).
3. Remove the 4 screws that secure the cover to the computer.
4. Pry the cover up to disengage it from the computer, and then pull it toward the top and off the
computer. You may experience significant resistance under the HP logo.
Figure 7-45 Removing the rear logo cover
To replace the rear logo cover, reverse the removal procedures.
Rear logo cover 71
To Next Page
Loading...
