HP u818x kit - Emergency Recording; Add Speed Point

22
3.3 Emergency Recording
To Start the Emergency Recording, do the following:
1. During Video Recording, press the
OK
button to enter emergency
recording mode, the “Emergency” message will be shown immediately on
the upper left corner of the screen, and the recorded file will be protected.
2. The emergency video recording length is same as the recording interval
setting. When the emergency recording length reaches the setting, the
system will return to the general recording mode.
Note:
1. If the
Collision Detection
function is enabled and a collision is detected, the camcorder will automatically trigger
the emergency recording.
2. The emergency file is created as a new file and saved in Emergency folder, which will be protected to avoid
being overwritten by normal loop recording. The Emergency folder will occupy 32% of available memory card
capacity. When the Emergency folder is full, the oldest emergency file will be automatically deleted by the newest
emergency file.
3.4 Add Speed Point
You may customize speed cam positions in this product.
1. When the GPS positioning is completed , press to update speed camera
points.
2. This product features a capacity of 50 speed cam positions. In case you are
trying to add more than that, the system prompts with message "Speed
Position is full".
Note:
You may delete custom speed cam positions by selecting the
Delete Last Position
or
Delete All Position
option
from the
Speed Position Management
menu. Please note that all of your existing speed cam positions are deleted
once the
Delete All Position option
is selected. Make sure you are ready to recreate your custom speed cam
positions before running this option.