HP u818x kit - Collision Detection

31
3.7.2 Motion and Collision Detection
- In normal loop recording mode, press and hold POWER key for 3 seconds,
the screen will show message “Press OK to power off or enter Motion
and Collision Detection after 10 sec.” Please wait for 10 seconds and the
camcorder will enter Motion and Collision Detection automatically. The
camcorder will turn off the screen temporarily, but still in standby
detection status. When the camcorder detects any motion in front of lens
or any vibration/collision, the video recording will be triggered and the
event will be recorded.
- To disable this function, press any key to wake up the screen, and press
again any key to resume to normal loop recording.
Note:
1. The video file taken in this mode will be saved in the “Emergency” folder.
2. The file size is according to Record Interval setting.
3.7.3 Timelapse
- In normal loop recording mode, press and hold POWER key for 3 seconds,
the screen will show message “Press OK to power off or enter Timelapse
after 10 sec.” . Please wait for 10 seconds and the camcorder will enter
Timelapse automatically. The camcorder will turn off the screen
temporarily, but in timelapse recording status.
- To disable this function, press any key to wake up the screen, and press
again any key to resume to normal loop recording.
Note:
1. The video file taken in this mode will be saved in the “Video” folder.
2. In this mode, the camcorder is continuously recording by one second one frame. For example, 30 minutes
recording will be saved in one minute.
3. The file size is according to Record Interval setting.
3.8 Collision Detection
If the Collision Detection function is enabled, this camcorder begins emergency
recording once it detects any collision. Sensitivity of the Collision Detection
function is set to Normal by default, if user wants to change the settings of
Collision Detection, do the following:
1. Press the
button to enter the OSD menu.
2. Press the / button to select Collision Detection, and then press
the
OK
button for entering function menu.
3. Press the / button to change the sensitivity of this camcorder’s
collision detection (High Sensitivity / Normal Sensitivity / Low Sensitivity /
Off), and then press the
OK
button for entering function menu.
4. Press the button return to recording screen.