REMOVAL AND REPLACEMENT OF COMPONENTS 103
Chapter 4
4 After pulling the drive 1 out, remove the four guide screws 2 from the drive.
5 Verify the jumper settings of the new drive are set correctly.
6 To install a drive, first remove the front bezel (page 80) and bezel blanks (page 80). Insert the four
guide screws 1 into the drive. Align the screws with the slots on the drive, and slide the drive 2 into
the unit until it snaps into place.
NOTE All optical drives may not fit in the bottom optical bay due to interference with the system board.
Check the fit of your drive before installing it into the bay.
7 Connect the drive, power, and audio cables.
NOTE The audio cable is included with Linux-based systems only. Windows-based systems do not
require the audio cable.
1
2
2
1
1
2
To Next Page
Loading...
