78 REMOVAL AND REPLACEMENT
Access Panel (Hood) Sensor (Optional)
To remove the hood sensor:
1 Disconnect power from the system (page 73) and remove the access panel (page 77).
2 Disconnect the hood sensor 1 from the system board.
3 Slide the hood sensor 2 forward as shown in the following illustration.
CAUTION The hood sensor bracket and the chassis contain sharp edges that present a safety hazard.
Be careful when sliding the hood sensor forward.
4 Pull the hood sensor 3 down and remove it from the chassis.
To replace the hood sensor, reverse the previous steps.
2
3
1
To Next Page
Loading...
