104 REMOVAL AND REPLACEMENT
Optical Drive (Desktop Position)
To remove an optional optical drive, you must first release the drivelock. To release the optical drive:
1 Disconnect power from the system (page 73), remove the access panel (page 77), and lay the
workstation on its side with the system board facing up.
2 Disconnect the audio 1, drive 2, and power 3 cables from the drive.
NOTE The audio cable is included with Linux-based systems only. Windows-based systems do not
require the audio cable.
3 After removing the front bezel and bezel blanks, press down on the yellow drivelock. As you press on
the yellow drivelock 1, gently slide the drive 2 out of the chassis.
3
2
1
2
1
To Next Page
Loading...
