100 REMOVAL AND REPLACEMENT
Battery
CAUTION Back up your CMOS (complementary metal oxide semiconductor) settings before removing
the battery, as all CMOS settings will be lost when the battery is removed. To back up the CMOS
settings, in (F10 Setup click File>Replicated Setup>Save to Removable Media.
To remove the battery:
1 Disconnect power from the system (page 73), remove the access panel (page 77), and lay the
workstation on its side with the system board facing up.
2 Press on the release tab 1 of the battery holder as shown in the following illustration.
3 Slide and lift the battery 2 out.
To install the battery, slide the battery back in until it snaps back into place.
2
1
To Next Page
Loading...
