106 REMOVAL AND REPLACEMENT
Diskette Drive (Optional)
To remove an optional diskette drive:
1 Disconnect power from the system (page 73), remove the access panel (page 77), and remove the
front bezel (page 80).
2 Disconnect the cables from the back of the diskette drive.
3 After removing the front bezel and bezel blanks, lift the green drivelock release tab 1 and slide the
drive 2 out at the same time.
To replace an optional diskette drive, reverse the previous steps. Align the screws with the slots on the
drive, and slide the drive into the unit until it snaps into place.
1
2
To Next Page
Loading...
