REMOVAL AND REPLACEMENT OF COMPONENTS 83
Chapter 4
Front Panel I/O Assembly
To remove the front panel I/O assembly:
1 Disconnect power from the system (page 73), remove the access panel (page 77), and remove the
front bezel (page 80).
2 Disconnect the front panel I/O assembly cable from the system board.
3 Remove the two screws 1 that hold the assembly bracket to the chassis as shown in the following
illustration.
4 Remove the two screws 2 that hold the bracket and assembly together and separate the shield away
from the front panel I/O assembly 3.
5 Slide the front panel I/O assembly 4 (with bracket attached) out about two inches away from the
chassis.
WARNING! The next step requires the removal of cables through the chassis. Some edges on the
chassis might be sharp. Care must be taken when removing these cables.
6 Slide the front panel cables through the chassis and out the front of the unit.
To replace the front panel I/O assembly, reverse the previous steps.
1
1
2
2
4
3
To Next Page
Loading...
