REMOVAL AND REPLACEMENT OF COMPONENTS 85
Chapter 4
Power Supply
To remove the power supply:
1 Disconnect power from the system (page 73) and remove the access panel (page 77).
2 Disconnect the power supply from the system board.
3 Disconnect all devices (optical drives, diskette drive, hard drives, and on select models, the graphics
card and IEEE-1394 card) from the power supply.
4 Remove the four screws 1 from the back panel.
5 Slide the power supply 2 toward the front and lift up to remove it from the chassis.
To install the power supply, reverse the previous steps.
1
2
To Next Page
Loading...
