102 REMOVAL AND REPLACEMENT
Optical Drive (Minitower Position)
To remove an optional optical drive, you must first release the drivelock. To release the optical drive:
1 Disconnect power from the system (page 73), remove the access panel (page 77), and lay the
workstation on its side with the system board facing up.
2 Disconnect the power 1, drive 2, and audio 3 cables from the drive.
NOTE The audio cable is included with Linux-based systems only. Windows-based systems do not
require the audio cable.
3 After removing the front bezel and bezel blanks, lift the green drivelock release lever 1 and gently
slide the drive 2 out of the chassis.
1
2
3
1
2
To Next Page
Loading...
