HP xw4200 - Solenoid Hood (Smart Cover) Lock (Optional)

REMOVAL AND REPLACEMENT OF COMPONENTS 79
Chapter 4
Solenoid Hood (Smart Cover) Lock (Optional)
To remove the solenoid lock:
1 Disconnect power from the system (page 73) and remove the access panel (page 77).
2 Disconnect the access panel lock cable 1 from the system board.
3 Using the FailSafe key, unscrew the two screws 2 from the back of the chassis as shown in the
following diagram.
4 Slide the access panel lock assembly 3 away from the chassis and out of the unit.
To replace the access panel lock assembly, reverse the previous steps.
2
1
3