80 REMOVAL AND REPLACEMENT
Front Bezel
To remove the bezel:
1 Disconnect power from the system (page 73) and remove the access panel (page 77).
2 Lift up on the two tabs 1 located on the front bezel.
3 Rotate the front bezel 2 away from the chassis as shown in the following illustration and remove the
bezel.
Bezel Blanks
To remove the bezel blanks:
1 Disconnect power from the system (page 73), and remove the access panel (page 80) and front
bezel. After removing the front bezel, gently pull the subpanel 1, with the bezel blanks secured in it,
away from the front bezel.
2 Remove the desired bezel blank 2 by pulling the blank away from the subpanel.
NOTE The bezel blanks are keyed to assist you in replacing the blanks. Also, the subpanel can be
rotated 90 degrees to install the optical drives in desktop orientation, if desired.
1
2
2
1
To Next Page
Loading...
