REMOVAL AND REPLACEMENT OF COMPONENTS 105
Chapter 4
4 After pulling the drive 1 out, remove the four guide screws 2 from the drive.
5 Verify the jumper settings on the new drive are set correctly.
6 To install a drive, insert the four guide screws 1 into the drive. Align the screws with the slots on the
drive, and slide the drive 2 into the unit until it snaps into place.
7 Connect the drive, power, and audio cables.
NOTE The audio cable is included with Linux-based systems only. Windows-based systems do not
require the audio cable.
1
2
2
1
1
2
To Next Page
Loading...
