HP xw4200 - Page 99

REMOVAL AND REPLACEMENT OF COMPONENTS 99
Chapter 4
PCI or PCI Express Installation
To install a PCI or PCI Express card:
1 Disconnect power from the system (page 73), remove the access panel (page 77), lay the
workstation on its side with the system board facing up, and remove the PCI retainer (page 97).
2 Lift the PCI levers 1 by first pressing down on them and then out.
3 Remove the PCI slot cover 2.
4 Install the PCI card (3, left) or PCI Express card (3, right) into the chassis. Verify that the keyed
components of the card align with the PCI socket. If installing a PCI Express card, plug in the power
supply cable, if required.
5 Close the PCI levers 4. If the PCI levers do not close, be sure all cards are properly seated and then
try again.
6 If installing a PCI Express card, plug in the power supply cable 5, if required.
Figure 4-2
PCI card installation (left) and PCI Express Card Installation (right)
1
1
4
3
4
2
1
1
2
3
4
4
5