REMOVAL AND REPLACEMENT OF COMPONENTS 109
Chapter 4
SATA
For more information on SATA hard drives and the SATA RAID configuration, see “SATA Devices” on
page 157.
To remove a SATA hard drive:
1 Disconnect power from the system (page 73), remove the access panel (page 77), and lay the
workstation on its side with the system board facing up.
2 Remove the cables as shown in the following illustration.
3 Pull the release latch 1 and remove the SATA drive 2 as shown in the following illustration.
1
2
To Next Page
Loading...
