EasyManua.ls Logo

HP xw4200 - Page 149

HP xw4200
206 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
POST AND ERROR MESSAGES 149
Chapter 5
164–Memory Size Error Memory configuration is incorrect. 1 Run Computer Setup (F10 Setup) or Windows
utilities.
2 Be sure memory modules (if any) are installed
properly.
3 If third-party memory has been added, test using HP
only memory.
4 Verify proper memory module type.
201–Memory Error RAM failure. 1 Run Computer Setup (F10 Setup) or Windows
utilities.
2 Ensure memory and continuity modules are installed
correctly.
3 Verify proper memory module type.
4 Remove and replace memory modules one at a time
to isolate faulty module.
5 Replace the faulty memory modules.
6 If error persists after replacing memory modules,
replace the system board.
207–ECC Corrected Single Bit
Errors in Memory Sockets y,y
Single Bit ECC error. 1 Verify proper memory module type.
2 Try another memory socket.
3 Replace memory module if problem persists.
213–Incompatible memory
Module in memory Sockets
X,X, X
A memory module in memory socket
identified in the error message is
missing critical SPD information, or is
incompatible with the chipset.
1 Verify proper memory module type.
2 Try another memory socket.
3 Replace memory with a module conforming to the
SPD standard.
214–DIMM Configuration
Warning
DIMMs not installed correctly (not
paired correctly).
See “Memory” on page 93 for the correct memory
configurations and reseat the DIMMs accordingly.
301–Keyboard Error Keyboard failure. 1 Reconnect keyboard with workstation turned off.
2 Check connector for bent or missing pins.
3 Ensure that none of the keys are depressed.
4 Replace keyboard.
303–Keyboard Controller Error I/O board keyboard controller. 1 Reconnect keyboard with workstation turned off.
2 Replace the system board.
304–Keyboard or System Unit
Error
Keyboard failure. 1 Reconnect the keyboard with workstation turned off.
2 Ensure that none of the keys are depressed.
3 Replace keyboard.
4 Replace system board.
402–Parallel Port 2 Address
Assignment Conflict
IRQ address conflicts with another
device.
Reset the IRQ.
Table 5-18 POST Error Messages (Continued)
Screen Message Probable Cause Recommended Action

Table of Contents

Other manuals for HP xw4200

Related product manuals