HP xw4200 - Page 92

92 REMOVAL AND REPLACEMENT
NOTE Store the processor in a safe place where it will not be damaged.
To replace the processor:
1 Raise the processor socket handle fully (the full swing angle of the lever is approximately 135
degrees).
CAUTION The contacts in the socket are delicate. Use extreme care when placing the processor in the
socket.
2 Line up the triangle on the corner of the processor with the triangle on the corner of the processor
socket and install the processor into the socket. Ensure that the underside of the processor is level
with the top of the top of the processor socket. Lightly press down on the top of the processor while
closing the socket lever.