System board architecture
The following image shows the HP xw6400 Workstation block diagram.
Figure 4-2 System board block diagram
Removal and replacement of components
This section discusses the procedures necessary to remove and install various hardware components
on your workstation. Review the safety and precautions and the
Service considerations on page 52, as
well as the Safety and Regulatory Information, before servicing or upgrading your system.
1. Read all safety information and precautions.
2. Locate and clear a suitable work area.
3. Shut down the system and remove power from the unit.
4. Gather your tools.
5. Service your unit.
6. Restore power to your unit.
Disassembly order
Use the following table to determine the sequence in which to remove the major components.
Predisassembly
(
Predisassembly
procedures on page 57)
ENWW Removal and replacement of components 59
To Next Page
Loading...
