Figure 4-32 Identifying the correct power connections for a typical configuration
Optical drive
Your workstation might have an IDE or SATA optical drive. To remove the optical drive:
1. Disconnect power from the system (
Predisassembly procedures on page 57), remove the side
access panel (
Side access panel on page 63) and remove the front bezel (Front Bezel
on page 64).
2. Disconnect the data 1, power 2, and audio 3 cables from the drive. The connector colors might be
different than illustrated.
NOTE: The audio cable is only required for Linux-based systems.
Figure 4-33 Disconnecting the cables from the optical drive
84 Chapter 4 Removal and replacement procedures ENWW
To Next Page
Loading...
