3. Lift the green drive-lock release lever 1 and gently slide the drive 2 out of the chassis.
Figure 4-34 Removing the optical drive from the chassis
To :
1. Lift the green drive-lock release lever while sliding the optical drive into the bay. When the optical
drive is partially inserted, release the drive-lock release lever and slide the drive inward until the
drive snaps into place, securing the drive.
CAUTION: Ensure that the optical drive is secure. Failure to do so can cause damage to the drive
when moving the workstation.
2. Connect the power, data, and audio (if required) cables to the drive and workstation.
NOTE: The audio cable is only required for Linux-based systems.
3. If you are installing more than one optical drive, route the cable as in the following image.
NOTE: The optical drive cable is routed under the system board.
Figure 4-35 Connecting the optical drive cable to the system board
ENWW Removal and replacement of components 85
To Next Page
Loading...
