HP Z27K G3 User Manual

20
3) Lift the DP connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
5) Solder the new component.
USB-C connector USBC
Repair the USB-C connector:
1) Use a soldering iron and a de-soldering pump to remove as much solder as possible from the pin.
2) Use a hot air gun to melt the solder on the pins
3) Lift the USB-C connector from the PCB.
4) Place the new component on the PCB. Be sure that it matches the PCB footprint.
Solder the new component

HP Z27K G3 Specifications

General

Screen Size	27 inches
Resolution	3840 x 2160 (4K UHD)
Panel Type	IPS
Aspect Ratio	16:9
Brightness	350 cd/m²
Contrast Ratio	1000:1
Refresh Rate	60 Hz
Color Gamut	99% sRGB
Viewing Angle	178° horizontal / 178° vertical
Pixel Pitch	0.1554 mm
Integrated Speakers	No
Tilt	-5° to +20°
VESA Mount	100 x 100 mm
Dynamic Contrast Ratio	10000000:1
Response Time	5 ms (GtG)
Ports	1 x DisplayPort 1.4, 1 x HDMI 2.0, 4 x USB-A 3.2 Gen 1
HDCP Support	Yes
Swivel	±45°
Pivot	90°
Weight (with stand)	7.4 kg
Height Adjustment	150 mm