HP Z27K G3 User Manual

13
4 Removal and replacement procedures
Adherence to these procedures and precautions is essential for proper service.
Preparation for disassembly
Use this information to properly prepare to disassemble and reassemble the monitor.
1) Read the “Important safety information” and “Important service information and precautions” sections in
the “Getting started” chapter of this guide.
2) Clean the room for disassembly.
3) Identify the disassembly area.
4) Check the position that the monitors are to be placed along with the number of monitors. Prepare the area
for material flow according to the disassembly layout.
5) Be sure to have the following equipment and materials:
 Press fixture
 Working table
 Screwdriver
 Knife
 Gloves
 Cleaning cloth
 ESD protection
 Scraper bar in the following dimensions:
Rear Cover
Before removing the Rear Cover, follow these steps:
▲ Prepare the monitor for disassembly. See Preparation for disassembly on page 13.
1) Pull the release button to remove Stand Base From Display Head

HP Z27K G3 Specifications

General

Screen Size	27 inches
Resolution	3840 x 2160 (4K UHD)
Panel Type	IPS
Aspect Ratio	16:9
Brightness	350 cd/m²
Contrast Ratio	1000:1
Refresh Rate	60 Hz
Color Gamut	99% sRGB
Viewing Angle	178° horizontal / 178° vertical
Pixel Pitch	0.1554 mm
Integrated Speakers	No
Tilt	-5° to +20°
VESA Mount	100 x 100 mm
Dynamic Contrast Ratio	10000000:1
Response Time	5 ms (GtG)
Ports	1 x DisplayPort 1.4, 1 x HDMI 2.0, 4 x USB-A 3.2 Gen 1
HDCP Support	Yes
Swivel	±45°
Pivot	90°
Weight (with stand)	7.4 kg
Height Adjustment	150 mm